橡膠研發(fā)用壓縮*變形器 

橡膠研發(fā)用壓縮*變形器

Rubber compression deformation
The tester consists of parallel plate limiter and a fastening piece, with GB7759, ISO815 requirements for vulcanized rubber,
Under the condition of normal temperature, high temperature and low temperature, the rubber deformation was measured by a certain compression rate.
Two. Technical parameters of rubber compression deformation:
1 sample:
A diameter 29mm height 12.5mm
B diameter 13mm height 6.3mm
2 limiter height: specimen type A B
Compression rate 25% ~ 9.3 ~ 9.4 ~ 4.7 ~ 4.8
Compression rate 15% ~ 10.6 ~ 10.7 ~ 5.3 ~ 5.4
Compression rate 10% ~ 11.25 ~ 11.3 ~ 5.65 ~ 5.7
3 dimension: diameter 115mm high 110mm
4 weight: 10Kg

橡膠壓縮變形器 http://www.jsfy17。。ｃｏｍ/ParentList-561049.html 
試驗器由平行鋼板限制器和緊固件組成,符合GB7759、ISO815要求,用于硫化橡膠,
熱塑性橡膠在常溫,高溫和低溫條件下,以一定壓縮率,經一定的壓縮時間后測定橡膠變形量。
二.橡膠壓縮**變形器技術參數:
1.試樣:
A型 直徑29mm 高度12.5mm
B型 直徑13mm 高度6.3mm
2.限制器高度:試樣類型 A B
壓縮率25%時 9.3～9.4 4.7～4.8
壓縮率15%時 10.6～10.7 5.3～5.4
壓縮率10%時 11.25～11.3 5.65～5.7
3.外形尺寸:直徑115mm 高110mm
4.重量: 10Kg

橡膠研發(fā)用壓縮*變形器